Rob Papen Predator Bedienungsanleitung PDF herunterladen (Seite 5)

Free on/off

When this is turned off, it returns an oscillator to its initial waveform position (phase) every

time you play a new note. When it's on, the oscillator phase continues from its last position, it

is "free-running". This is useful in spread sounds because it spreads the initial 'attack' part of

the sound.

Sync on/off (Osc.2 and Osc.3)

Sync is only available for Oscillator 2 and Oscillator 3. If you switch it on, the oscillator

frequency synchronizes to Oscillator 1. This means that when oscillator 1 finishes the wave

cycle, it resets the synced oscillator to the initial position. This means that the oscillator gest

reset and its frequency bound to Oscillator 1. You can hear it very well if you detune, for

instance, Oscillator2 and then turn Sync on.

The detuning disappears, and it now has the same pitch as Oscillator 1. However, Oscillator 2

will sound different because Oscillator 1 resets Oscillator 2 whenever it reaches the end of its

wave cycle. Typically this will add to the harmonic content (additional overtones) to the basic

waveform.

Listen to patch "Predator-RE SyncLead" of the first folder for an example.

Semi

This controls the root pitch setting of the oscillator, with semitones you can alter the tuning

from -48 semitones down (-4 octaves) to 48 semitones up (+4 octaves) from the base note.

Fine

Located next to the semi knob, fine sets the fine-tuning of the oscillator with a range of -

100cent up to +100cent.

Track

The track button is located at the very top of the semi button. With track set to on the

oscillator follows the keyboard in pitch. When it is off the pitch of the oscillator stays the same

independent of what key is played. In the case of FM or Ring Modulation, or for FX sounds it

can be handy if you can turn this setting off.

Octave up/down

Next to the track control you can find an up and down arrow. Pressing up increases the

oscillator tuning by an octave, pressing down decreases the oscillator tuning down by an

octave.

Sub

This knob controls the volume of the oscillator's sub-oscillator. The sub-oscillator is a square

wave, which is one octave lower than the normal oscillator pitch. The sub-oscillator pitch is

always connected to the oscillator pitch, so if you detune the oscillator, the sub-oscillator

detunes along with it.

Spread

This is a special Predator-RE function. If you open this control knob, a multiple oscillator

sound is generated using one oscillator. The spread knob controls the level of detuning for

these multiplied oscillators. If you keep spread to 0 level, a normal oscillator is generated.

1 2 3 4 5 6 7 8 9 10 ... 53 54

Keine Kommentare

Rob Papen Predator Bedienungsanleitung Seite 5